Using The Sound Retriever; Enhancing Dialogue; Using The Tone Controls; Adjusting The Bass And Treble - Pioneer DCS-575 Mode D'emploi

Listening to your system
Use / to select EQ ON or EQ OFF then
2
press ENTER to confirm.
• If you select EQ OFF, equalization is set to
off but speaker settings (channel delay and
channel level) remain in effect.
• EQ ON is selected automatically after the
Auto MCACC setup is completed.

Using the Sound Retriever

When audio data is removed during the WMA/
MP3/MPEG-4 AAC compression process,
sound quality often suffers from an uneven
sound image. The Sound Retriever feature
employs new DSP technology that helps bring
CD quality sound back to compressed 2-
channel audio by restoring sound pressure
and smoothing jagged artifacts left over after
compression.
• While listening to a stereo source, press
SOUND RETRIEVER to switch the sound
retriever on or off.

Enhancing dialogue

The Dialogue Enhancement feature is
designed to make the dialogue stand out from
other background sounds in a TV or movie
soundtrack.
Press SOUND and use / to select
1
DIALOGUE then press ENTER.
Use / to select the amount of
2
dialogue enhancement then press ENTER to
confirm.
Select between OFF, MID or MAX.

Using the Tone controls

You can change the tonal balance of the sound
by using the tone control menu.
Press SOUND and use / to select
1
TONE then press ENTER.
Note
1 The Bass Mode is not available when headphones are connected.
Use / to select the option you want to
2
adjust and press ENTER.
The Bass/Treble, Quiet and Midnight features
cannot be used at the same time.

Adjusting the bass and treble

Use the tone controls to adjust the bass and
treble.
Use / to select BASS or TREBLE then
•
use / to adjust the tone. Press ENTER to
confirm.

Quiet and Midnight modes

The Quiet listening feature reduces excessive
bass or treble in a sound source.
The Midnight listening feature allows you to
hear effective surround sound of movies at low
volume levels.
• After pressing ENTER, the setting
switches on/off.
• To cancel the Quiet or Midnight listening
modes, select BASS/TRE.

Boosting the bass level

There are two bass modes you can use to
enhance the bass in a source.
Press SOUND and use / to select
1
BASSMODE then press ENTER.
Use / to adjust the sound then press
2
ENTER to confirm.
Select between OFF, MUSIC or CINEMA.
03
1
17
En