Getting Started; Making Settings Using The Setup Navigator Menu - Pioneer MCS-838 Mode D'emploi

Capter 3

Getting Started

Making settings using
the Setup Navigator
menu
Be sure to perform these settings when using
the player in the following situations.
After Initial Setup format.
After updating the player's software.
Caution
Before turning on the power, check that the
connections between the player and other devices
are correct. Also, turn on the power of the devices
connected to the player before turning on the
player's power.
projector compatible with the Control function,
set Control to On on the connected device before
turning on the player's power.
1. Turn on the TV's power and switch the
input.
See the TV's operating instructions for the
details of operating the TV.
2. Turn on the player's power.
Press
STANDBY/ON.
Check that the Setup Navigator menu is
displayed.
If the Setup Navigator menu is not
displayed
Press HOME MENU to display the
Home Menu, select Initial Setup
Start, then press ENTER.
Navigator
3. Start Setup Navigator.
Press ENTER.
Setup Navigator starts.
4. Select the OSD language.
Use / to select, then press ENTER.
is compatible with Control function is
connected to this player's HDMI OUT
terminal, language settings are imported
from the Pioneer Flat Screen TV's language
settings before Setup Navigator begins.
5. Select the appropriate output resolution
for the connected TV.
Use / to select, then press ENTER.
6. Select the appropriate aspect for the
connected TV.
Use / to select, then press ENTER.
7. Close the Setup Navigator menu.
Press ENTER.
Setup Navigator finishes and the setting
is stored.
Press RETURN to go back to the
previous screen.
Getting Started 45
En
Setup
3