About This Document; For Your Safety - Aventics ST4-2P Série Mode D'emploi

English
1

About this document

These instructions contain important information on the
safe and appropriate installation and operation of the ST4-
2P sensor.
Read these instructions completely, especially chapter
O
2 "For your safety" on page 4, before working with the
ST4-2P sensor.
Related documents
The ST4-2P sensor is a system component. Also observe
the system documentation from the system manufacturer.
2

For your safety

The ST4-2P sensor has been manufactured according to
the accepted rules of safety and current technology. Even
so, there is a risk of injury or damage if the following
general safety instructions and the specific warnings given
in this instruction manual are not observed.
Read these instructions completely before working with
O
the ST4-2P sensor.
Keep these instructions in a location where they are
O
accessible to all users at all times.
Always include the operating instructions when you
O
pass the ST4-2P sensor on to third parties.
Intended use
The ST4-2P sensor is for commercial use only
O
Only use the ST4-2P sensor in AVENTICS handling
O
devices with C-groove.
The pressure regulator may only be used within the
O
limits listed in the technical data.
Intended use includes having read and understood these
instructions, especially the chapter "For your safety".
Improper use
It is considered improper use when the ST4-2P sensor
is used for any application not stated in these
W
instructions, or
is used under operating conditions that deviate from
W
those described in these instructions.
Personnel qualifications
Assembly and commissioning require basic electrical and
pneumatic knowledge. Assembly and commissioning may
therefore only be carried out by qualified electrical or
pneumatic personnel or an instructed person under the
direction and supervision of qualified personnel. Qualified
personnel are those who can recognize possible hazards
and institute the appropriate safety measures due to their
professional training, knowledge, and experience, as well
as their understanding of the relevant conditions pertaining
to the work to be done. Qualified personnel must observe
the rules relevant to the subject area.
AVENTICS | ST4-2P | R412012414–BAL–001–AE
Safety instructions in this document
Structure of safety instructions
Hazard type and source
Consequences of non-observance
Measures to avoid hazards
O
Meaning of the signal words
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
Indicates damage to property: The product or its environment
may be damaged.
Symbols
Operation may be impaired if this information is
disregarded.
The following must be observed
General instructions:
Observe the local regulations to protect the
W
environment in the country of use and to avoid
workplace accidents.
Do not change or modify the device.
W
Only use the device within the performance range
W
provided in the technical data.
The ST4-2P sensor is not a safety component in terms
W
of the machine directive.
Use a power source in compliance with IEC/
W
DIN EN 60204-1.
During assembly:
Make sure the relevant system component is not under
W
pressure or voltage before assembling the product or
when connecting and disconnecting plugs.
Protect the system against being switched on. Hang
W
signs on the main switch that warn workers against
switching the system on.
Avoid ferritic parts in the immediate vicinity of the ST4-
W
2P sensor.
During operation:
Only commission the sensor after it has been
W
completely assembled, as well as correctly connected
and tested.
SIGNAL WORD
WARNING
CAUTION
NOTICE
4