Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Make sure that the cabinet is prepared according to the dimensions of the cooker hood
Note:
If necessary, you can remove the back of the cabinet.
Note:
If the installation includes a plasma filter, the opening in the cabinet has to be 660 mm.
3. Install the seal for non-flush installations of the induction hob. Refer to section
For an overview of the items for installing the appliance, refer to section
For an overview of the items for installing the accessories, refer to section
INSTALLING THE SEAL
Caution:
The seal must be installed before you install the induction hob. Do not install the appliance without the
seal.
Note:
This procedure is only valid for non-flush installtions of the appliance.
1. Remove the protective film (B) from the seal (A).
2. Put the seal around the appliance. Make sure that there is a distance of 2 mm between the appliance and the
seal.
INSTALLING THE INDUCTION HOB
Caution:
Do not block the ventilation openings of the appliance.
Non-flush installation
1. Put the appliance in the opening of the worktop.
Flush installation
1. Apply sealant along the edges of the appliance.
2. Put the appliance in the opening of the worktop.
3. Remove too much sealant.
CHANGING THE OUTPUT DIRECTION OF THE MOTOR
The output direction of the motor can be on the left or on the right side of the cooker hood.
1. Remove the screws.
2. Remove the two covers (A) and (B).
3. Turn the motor (C) to the opposite direction.
4. Install the two covers. Use the screws.
REPLACING THE DUCT ADAPTER
For kitchen cabinets with a depth up to 750 mm or with a depth of more than 810 mm you can replace the duct
adapter to increase the space for the drawers.
Removing duct adapter 1
1. Remove the screws.
©
).
'Installing the seal'
'Installation items'
.
'Accessories'
.
English
(Figure 9)
.
(Figure 10)
(Figure 11)
(Figure 11)
(Figure 12)
•
25
Publicité
Table des Matières
