Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Extracting
The cooking fumes are released through a pipe that is connected to the outlet of a motor. Installing the appliance in
this way gives the best results.
Using a long pipe with a lot of bends or a pipe with a diameter smaller than the outlet of the motor decreases the
performance of the appliance and increases the noise that is produced.
Warning:
Never connect the pipe to a duct that contains gas or other fuels.
Note:
Pipes (Naber system) are not supplied.
Filtering (recycling)
The cooking fumes go through a charcoal filter. The filter purifies the fumes and recycles these back to the kitchen.
The charcoal filter can be placed in the base of the cabinet. Two possible grids are available for installation (10 cm
and 6 cm), refer to section
Using a charcoal filter decreases the performance of the appliance. It is recommended to install the appliance in the
extracting mode.
Note:
A charcoal filter is not supplied.
Using a plasma filter
The cooking fumes go through a plasma filter. Refer to the user manual of the plasma filter for correct use.
Note:
A plasma filter is not supplied.
4
Installation
SAFETY INSTRUCTIONS FOR INSTALLATION
•
Follow the installation procedures completely.
•
After installation, make sure that the appliance is assembled correctly. Incorrect assembly may lead to dangerous
situations. The installer is liable for damage caused during incorrect installation.
•
Only a qualified electrician is allowed to electrically connect the appliance.
•
The appliance must be installed according to national and regional safety instructions.
•
The appliance has protection class I and may only be used in combination with an earthed connection. The
manufacturer is not liable for unsuitable operation and possible damage caused by unsuitable electric
installations.
•
The appliance must be connected to a permanent installation in which provisions for switching off are integrated,
in accordance with the installation instructions.
•
The appliance may only be installed above a drawer or an oven with forced ventilation. There must be a minimum
distance for ventilation.
•
Do not install the appliance above a refrigerator, oven without ventilation, washing machine or dishwasher.
•
Make sure that the mains cable does not get jammed during installation or is running along sharp edges. If an
oven is installed below it, make sure that the mains cable goes via the rear corners of the oven to the connection
box. The mains cable must be placed in such a way that no contact is made with hot parts of the appliance or the
oven.
•
The connection point, mains socket and/or mains plug must always be accessible.
•
The worktop on which the appliance is placed must be flat, horizontal and stable. Observe the instructions from
the manufacturer of the worktop.
•
In case of incorrect installation or connection, the warranty becomes invalid.
•
Any change to the appliance, including replacement of the mains cable, must be performed by a certified installer.
22
•
English
'Accessories'
.
Publicité
Table des Matières
