Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Warning:
Obey the requirements for installation.
(Figure 4)
•
Make sure that the dimensions of the cabinet are suitable for installing the appliance. Refer to the figure.
•
Make sure that the minimum height of the plinth of the cabinet is 100 mm so that the air ducts can pass below
the cabinet.
Note:
There are accessories available for plinths with a height up to 60 mm. Refer to the website of the
manufacturer.
•
Make sure that you use heat resistant glue (100°C) to prevent changes in shape and color.
(Figure 5)
•
Install the appliance without adjacent kitchen furniture or a wall on both sides (A) or with kitchen furniture on only
one side of the appliance (B and C).
•
Do not install the appliance with kitchen furniture on both sides that is higher than the appliance (D). There is a
risk of fire.
•
Do not use wooden decoration plates or boards.
•
There must be a minimum distance of 760 mm between the appliance and any kitchen furniture that is located
above the appliance.
•
There must be a distance of 50 mm between the appliance and the wall or the sides of the kitchen furniture.
(Figure 6)
•
If the appliance is installed above a drawer, make sure that there is a minimum space of 30 mm for the
ventilation openings at the bottom of the appliance.
(Figure 7)
•
The upper drawer inside the kitchen cabinet can have a maximum depth of 450 mm or 400 mm and the lower
drawer of 350 mm or 300 mm. This depends on the installation direction of the motor of the cooker hood.
UNPACKING
1. Remove the packaging.
Caution:
Make sure that you remove all labels and stickers from the ceramic glass.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.
PREPARING FOR INSTALLATION
1. Make sure that the worktop is prepared according to the dimensions of the induction hob (A).
Note:
Use dimensions B if the appliance must be flush with the worktop.
24
•
English
(Figure 8)
Publicité
Table des Matières
