Installation - Inventum IKI9040 Manuel D'utilisation

Item
Timer display
Timer indicator
Operation indicator
Memory button
On/off button
Up button
Keep-warm mode button
Down button
Pause button
Bridge mode button
Selection/timer button
SAFETY PROVISIONS
Pan detection mode
With the pan detection mode, the appliance does not work if you use an unsuitable pan or if the appliance does not
detect a pan on a cooking zone. The operation indicator shows U and it is not possible to increase the power level.
Residual heat indicator
After stopping the appliance, the cooking zones stay hot. If you touch a hot cooking zone this may result in injury.
The operation indicator shows H to indicate the cooking zone is hot. When the cooking zone is cool, the operation
indicator no longer shows H.
Automatic switch-off
If you do not change the power level for a defined period of time, the cooking zone automatically switches off. The
maximum cooking time depends on the set power level. For an overview of the amount of time for each power level,
'Automatic switch-off times'
refer to section
4

Installation

SAFETY INSTRUCTIONS FOR INSTALLATION
• Make sure that the appliance is assembled correctly. Incorrect assembly may lead to dangerous situations. The
installer is liable for damage caused during incorrect assembly.
• Only a qualified electrician is allowed to electrically connect the appliance.
• The appliance must be installed according to national and regional safety instructions.
• The appliance has protection class I and may only be used in combination with an earthed connection. The
manufacturer is not liable for unsuitable operation and possible damage caused by unsuitable electric
installations.
• The appliance must be connected to a permanent installation in which provisions for switching off are
integrated, in accordance with the installation instructions.
• The appliance may only be installed above a drawer or an oven with forced ventilation. There must be a
minimum distance for ventilation.
• Do not install the appliance above a refrigerator, oven without ventilation, washing machine or dishwasher.
• Make sure that the mains cable does not get jammed during installation or is running along sharp edges. If an
oven is installed below it, make sure that the mains cable goes via the rear corners of the oven to the
connection box. The mains cable must be placed in such a way that no contact is made with hot parts of the
appliance or the oven.
• The connection point, mains socket and/or mains plug must always be accessible.
• The worktop on which the appliance is placed must be flat, horizontal and stable. Observe the instructions from
the manufacturer of the worktop.
Function
To show the set time.
To show that a timer is set.
To show the set power level or the activated mode.
To save the settings.
To start or stop the appliance.
To increase the power level or set time.
To start or stop the keep-warm mode.
To decrease the power level or set time.
To pause the appliance.
To start or stop the bridge mode.
To select a mode or use the timer.
.
• 29
EN