Ledi ® Reverso Model: Mains Current/Time Code/Display; Impulse Receiver And Afnor Nfs 87500 Time Code Receiver Versions; Radio-Synchronized By Tdf, Dcf Or Gps Versions; Ascii Rs232 Or Rs422 Version - Gorgy Timing LEDI Mode D'emploi

3.2. LEDI REVERSO MODEL: MAINS CURRENT/TIME CODE/DISPLAY
®
► Connect the 230 VAC 50-60Hz mains to the twin-lead cable.
Connections are made directly on the cables outside the bracket without having to open
the case.
► To access the pushbuttons and the start switch, unscrew and gently push down the
hatch on the bottom of the case.
► After connecting the clock, put the switch on "ON".

3.2.1. Impulse receiver and AFNOR NFS 87500 time code receiver versions

► Connect the cable to the output CODE of the master clock (no polarity).

3.2.2. Radio-synchronized by TDF, DCF or GPS Versions

► No wiring required.
☛
To position your antenna, please refer to instructions on antennas
CDG020/021 or web site www.gorgy-timing.fr section user manual.

3.2.3. ASCII RS232 or RS422 Version

► Connect the cable to the output TXD, RXD & GND of the master clock.

3.2.4. SMPTE version

► Connect SMPTE code on the terminal marked CODE of the terminal plug (no polarity).

3.2.5. Version NTP

► Connect the Ethernet wire on the Ethernet outlet available on the item.

3.2.6. TOP option

► Connect the cable on the both wires outgoing from the clock: brown wire and white
wire
► Static relay output: no polarity
► TTL 50 ohms output: brown wire is GND, white wire is positive impulse
► Sine wave output 1000Hz: brown wire is GND, white wire is frequency

3.2.7. ASCII RS232 or RS485 output option

► Connect the cable marked TXD, RXD et GND on the entry of the material (master
clock, the other clock, PC, etc.)
76
usermanual "MDE-ANTENNES-0085" available on:
MDE-LEDI-1099V3.4