gourmetmaxx Z 00794 Mode D'emploi page 22

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
7. Move the switch to the AN (on) position to switch on the device. The operating lamp
in the On / Off switch lights up.
The coffee machine has a non-drip valve. You can also take the coffee jug from
the hotplate during the brewing process and pour yourself a cup of coffee. But be
careful: You should place the coffee jug back on the hotplate within approx. 20
seconds to prevent the permanent fi lter from overfl owing with water!
8. Wait until no more coffee fl ows out of the coffee outlet opening. You can now remove
the glass jug.
9. If you want to switch off the device after the brewing process, move the On / Off
switch to the AUS (off) position.
10. If the coffee is to be kept warm, leave the coffee jug on the hotplate with the device
switched on. The hotplate switches off automatically after approximately 15 minutes.
When the device switches off, the operating lamp goes out.
Oven
CAUTION!
Make sure that the food that you would like to prepare does not come into contact
with the heating elements of the device.
Do not place food wrapped in cling fi lm or plastic bags into the device.
Do not place food containing fat or oil directly onto the rack so that the bottom heating
elements are not contaminated by fat/oil dripping down. Use the baking tray supplied
with the device!
1. Open the glass door.
2. As required, use just the rack or the rack and the baking tray.
3. Place the food onto the rack or baking tray. Then close the glass door.
4. Turn the operating switch clockwise to the function you want.
5. To start the heating process, use the TIMER to set the time you want (maximum 15
minutes). The control lamp lights up after the time has been set on the timer.
If the TIMER is on AUS (off), the oven is not switched on.
6. When the set time has elapsed, a buzzer is heard and the device automatically stops
any further supply of heat. Then turn all dials to AUS (off).
7. If you want to stop the heating process prematurely, turn the timer to the AUS (off)
position to switch off the device. Then turn all dials to AUS (off).
8. Open the glass door and carefully remove the baking tray and the prepared food.
Always use potholders or oven gloves to do this. Always place the hot baking tray on
a heat-resistant surface.
Pan
1. Turn the operating switch clockwise to Top heat.
2. To start the heating process, use the TIMER to set the time you want (maximum 15
minutes). The control lamp lights up after the time has been set on the timer.
If the TIMER is on AUS (off), the oven is not switched on.
00794_DE-EN-FR-NL_A5_V1.indb 22
00794_DE-EN-FR-NL_A5_V1.indb 22
22
22.06.2016 10:32:44
22.06.2016 10:32:44

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wk-1107

Table des Matières