LaserLiner AQua-Master Mode D'emploi page 19

Working with the SensoCommander (optional)
Control panel SC 120 and Pro
18
17
16
Note: The laser receiver has two tolerance settings: Precision and free-hand
setting. On the SensoCommander 120, the settings are indicated by LEDs:
precision setting: green; free-hand setting: orange. On the SensoCommander
Pro and Classic, changeover between the settings is done by the
Precision range:
Mode with smaller
tolerance for precise
alignment (e.g. with
measuring staff).
The SensoCommander can recognise the laser beam
over long distances. Move the SensoCommander up
and down through the laser beam until the middle
display appears. Now mark the height on the all-round
marking groove. The Spotlite additionally shows the
measured height (not on SC CoolBlue).
Universal mount (optional):
The receiver can be installed on levelling staffs with the aid of
the universal mount. To do this, insert the universal mount into
the laser receiver and secure on the levelling staff with the aid
of the screw. To release the universal mount from the laser
receiver, turn the quick release lock in the direction of the
arrow.
SC Classic
14
15
(volume)
Free-hand range:
Mode with greater
tolerance for less precise
alignment by hand.
ENGLISH
AQua-Master
14 Position
16
15 Speed / Volume /
Angle range
16 Hand receiver mode
15 17 Scan mode
18 Rotation mode
Volume adjustment feature
on SC 120 and Pro.
button.
Volume
adjustment:
1
2
19