Clock Adj In/Out Terminals - Sony SVO-1330 Mode D'emploi

Terminals

CLOCK ADJ IN/OUT terminals

If you connect the CLOCK ADJ IN/OUT terminals of
the VCRs, you can adjust the clock of all the connected
VCRs simultaneously in the following cases:
– when the clock of VCR 1 comes to the set time
– when you input a signal from an external switch
VCR 1
to CLOCK ADJ OUT
VCR 2
to CLOCK ADJ OUT
VCR 3
When using an external switch
Connect the external switch between the CLOCK ADJ
IN terminal and the GND terminal of VCR 1.
24
(US)
to CLOCK ADJ IN
to CLOCK ADJ IN
Setting the clock adjustment time
1
Press MENU and select 3.SET UP/USED TIME
using SHIFT v, then press SHIFT b.
The SET UP menu appears on the screen.
2
Press SHIFT v to flash the setting of "CLOCK
ADJ."
3
Set the time you want to adjust the clock using
DATA +/–.
[ SET UP ]
TAPE T-120
END ALARM END
TAPE END REW
APC ON
CLOCK ADJ 0 1 : 0 0
BUZZER ON
THREAD CHECK ON
[ USED TIME ]
HEAD 00005H
When using the clock of VCR 1:
When the clock of VCR 1 comes to the time set
on "CLOCK ADJ," the signal will be output
from the CLOCK ADJ OUT terminal to adjust
the clocks of all the connected VCRs.
When using an external switch:
When you turn on the switch and its signal is
received at the CLOCK ADJ IN terminal of
VCR 1, the clocks of all the connected VCRs
will be adjusted to the time set on "CLOCK
ADJ."
4
Press MENU twice to return to the normal display.