Monitoring The Recording Condition; Checking The Tape Threading - Sony SVO-1330 Mode D'emploi

3
Set "TAPE END" to REW or EJECT using DATA
+/–.
[ SET UP ]
TAPE T-120
END ALARM END
TAPE END REW
APC ON
CLOCK ADJ 0 1 : 0 0
BUZZER ON
THREAD CHECK ON
[ USED TIME ]
HEAD 00005H
REW: when the tape comes to the end, the VCR
rewinds the tape automatically and enters stop
mode at the beginning of the tape.
EJECT: when the tape comes to the end, the tape
is ejected automatically.
4
Press MENU twice to return to the normal display.
Monitoring the recording
condition
You can check the recording condition by pressing
(PLAY while recording.
6
Press (PLAY while recording.
After the tape is rewound for about three seconds and
played back for about two seconds, the unit returns to
the original recording mode.
Notes
• While monitoring the recording condition, recording
is interrupted.
• When the recording is not performed correctly, an
alarm signal is output from the WARNING OUT
terminal.

Checking the tape threading

To ensure correct operation, the VCR checks
automatically the tape threading whenever you insert a
tape, and it takes about 5 seconds. If an error is
detected, the VCR ejects the tape.
During this period, tape operation buttons such as (
PLAY, r REC, ) FF and 0 REW do not
function.
If you consider it unnecessary to check the tape
threading, you can cancel it in the SET UP menu.
1
Press MENU and select 3.SET UP/USED TIME
using SHIFT v, then press SHIFT b.
The SET UP menu appears on the screen.
2
Press SHIFT v to flash the setting of "THREAD
CHECK."
TAPE
END ALARM
TAPE END
APC
CLOCK ADJ
BUZZER
THREAD CHECK
3
Set to OFF to cancel the tape threading check
using DATA +/–.
r P
p 0 ( )
TAPE
END ALARM
TAPE END
APC
CLOCK ADJ
(PLAY
BUZZER
THREAD CHECK
4
Press MENU twice to return to the normal display.
[ SET UP ]
T-120
END
REW
ON
0 1 : 0 0
OFF
ON
[ USED TIME ]
HEAD 00005H
[ SET UP ]
T-120
END
REW
ON
0 1 : 0 0
OFF
OFF
[ USED TIME ]
HEAD 00005H
15
(US)