Configuring The Battery Type - Ingeteam INGECON SUN STORAGE 1Play Manuel D'installation

Ingeteam
Setting
FAC Auxiliary grid/genset frequency (Hz).
PAC Auxiliary grid/genset active power (w).
COSPHI Cosine of Phi. Cosine of the phase shift angle between the grid voltage and current. The
cosine of phi can be positive or negative:
Digital I/O
Setting
OUTPUT 1 Status of digital output 1. The following states may be shown: On, Off.
OUTPUT 2 Status of digital output 2. The following states may be shown: On, Off.
INPUT 1 Status of digital input 1. The following states may be shown: On, Off.
INPUT 2 Status of digital input 2. The following states may be shown: On, Off.
Alarm
Setting
ALARM Status of inverter alarms in hexadecimal format.
CODE1 Operating code of the unit in hexadecimal format.
CODE2 Operating code of the unit in hexadecimal format.
Firmware
Setting
FW VER. Unit firmware version.
DFW VER. Unit display firmware version.
D. BOOT Unit display boot version.
SVN FW Unit firmware revision.
SVN D. Display firmware revision.
Data
Setting
N/S Unit serial number.
COMM. NODE Number assigned to the inverter to identify it in a Modbus grid.
TEMP. RAD. Unit radiator temperature.
TEMP. CI Unit internal temperature.
TEMP. PT-100 PT-100 temperature sensor.

18.6. Configuring the battery type

CAUTION
The battery type selection in the configuration process must be done with caution. The battery manufacturer
does not offer any warranty if the battery type is configured incorrectly in the inverter.
For example, if a lead-acid battery is selected in the inverter when the battery is actually Li-Ion, it may be
damaged.
62
• Positive: the inverter injects positive reactive energy. The current is ahead with
respect to the voltage.
• Negative: the inverter injects negative reactive energy. The current is delayed with
respect to the voltage.
Explanation
Explanation
Explanation
Explanation
Explanation
ABH2013IQM01_C- Installation and Operation Manual
Display control