Ingeteam INGECON SUN STORAGE 1Play Manuel D'installation page 51

Connecting optional accessories
To connect the INGECON SUN EMS Board follow these steps:
1. Connect the EMS Board to connectors J11 and J12 of the control card as shown in the figure below.
2. If you wish to establish Wi-Fi communication with the router, you must install the Wi-Fi antenna and the
Reset button. Follow the instructions in section "16.2.3. Wi-Fi TCP communication card".
3. If you wish to use Ethernet communication with the router, insert the communication cabling through the
dedicated PG20 cable gland (see "2.7. Description of cable inlets").
4. In the case of using the Wi-Fi connection, connect the Reset button together with the extension cable
provided (A) and the antenna (B) to the EMS Board. To use the Ethernet connection, connect the cabling
to the EMS Board (C).
ABH2013IQM01_C - Installation and Operation Manual
C
A
B
INGECON SUN EMS Board
J11
J12
D
Ingeteam
EN
ES
FR
PT
51