Electrical Connection; Important Remarks - Cardin CRL170 Mode D'emploi

• Fit the second half crown wheel "27" and fasten it into position with
the screw "19" using the 6 mm Allen key "9".
• Rotate the crown wheel "27" through 180° to gain access to the
second fastening hole. If the crown wheel doesn't rotate, make sure
you have followed the paragraph "Manual release cable installation"
on page 7 and you have unscrewed the hand grip "22" as shown in
fig. 9.
• Insert the screw "20" and fasten it down using the using the 6 mm
Allen key "9".

ELECTRICAL CONNECTION

Important remarks

• Before connecting the appliance make sure that the voltage and
frequency rated on the data plate conform to those of the mains
supply.
• The power cable must be made of polychloroprene in conformity
with the international standard 60245 IEC 57 (e.g. 3 x 1.5 mm
H05RN-F).
• The cable may only be replaced by qualified technicians.
• An all pole trip switch with at least 3 mm between the contacts
must be installed between the unit and the mains supply.
• Don't use cables with aluminium conductors; don't solder the ends
of cables which are to be inserted into the binding posts; use cables
marked T min 85°C and resistant to atmospheric agents.
• The terminal wires must be positioned in such a way that both the
wire and the insulating sheath are tightly fastened.
Fig. 12
9
27
Fig. 13
All rights reserved. Unauthorised copying or use of the information contained in this d
27
Fig. 14
20
• Work out the run of the power and command cables according to
the installation requirements .
• Wire the 4 x 1 mm cable "44" to the motor's terminal board. The
2
yellow and green earth wire should be wired to the specific terminal
"45" on the motor.
44
• Pass the power cable "44" through the hole "17" fig. 3 avoiding
any contact with mechanical moving parts until it exits to the left or
right of the shutter support shaft.
• Fit the terminal board cover using the two screws "25" and "26".
45
• The minimum requirements for the electronic control unit are:
- output for one 230V 650W motor for the model CRL170E;
- output for one 230V 650W motor for the model CRL180E;
- output for one 230V 1300W or the model CRL360DE;
- opening button;
- closing button.
CONTROL UNIT
TC
01 02
• Wire the power cable "44" to the electronic control unit. In the
example shown in figure 17 we have connected:
- the brown wire to binding post 4;
2
- the black wire to binding post 5;
- the blue (neutral) wire to binding post 6;
- the yellow and green (earth wire) to binding post 7.
• Press the opening button "TA". The motor, not yet fixed to the rolling
shutter, will rotate to the completely open position.
• If the motor rotates in the wrong direction (closing) invert the black
and brown wires on the control unit.
• Reset the control unit, press the opening button TA" again and then
press the closing button "TC".
11
45
Fig. 17
M
TA
c
03 04 05 06 07
Fig. 15
Fig. 16
31