Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• At this point the components on the work bench should look
something like those indicated in figure 5.
29
34
31
32
27 - crown wheel;
28 - rubber needle bearing;
29 - upper half bearing block;
30 - upper half bearing block;
31 - terminal board cover;
32 - manual release hand-grip;
33 - Ø10 mm motor - rolling shutter fastening screw and washer;
34 - geared motor unit.
Geared motor installation part I
34
• Position the geared motor "34" over rolling shutter support shaft
and align the hole "35" with the hole "16" previously drilled at
5,5 cm from the centre of the shutter axis "15.
• Fasten the upper half-bearing block "29" to the lower block "30"
using the four M8 "21, 22, 23, 24" screws previously removed
using the 6 mm Allen key.
• Fasten the M10 screw "36" using the spanner "7" and make sure
it enters into the rolling shutter support shaft through the 10,5 mm
hole "16" (drilled in fig. 3).
Fig. 5
28
27
30
33
Fig. 6
35
16
Fig. 7
29
30
36
MANUAL RELEASE CABLE INSTALLATION
18
37
• Pass the release cable "37" through the hole "18" and thread it through
the tube until it exits to the left or right of the shutter support shaft. Cut
the electric brake release cable to the correct length with the cable cutter
"12" depending on the final position of the release hand grip "32".
39
41
38
32
• Unscrew the nut "38" using the 10 mm spanner "9" and slide off the
screw nipple "39" from the release cable "40".
• Strip the end of the cable "40", remove the end cap "41" and fit it to the
end of the cable just cut.
• Pass the steel cable through the hand grip "32", pull the cable core "40"
using the pliers "12" , thread it into the screw nipple "38" and fasten
down with the nut "39".
• Tighten the release cable adjustment nut "42" (fig. 10) on the motor "34".
• Unscrew the hand grip "32" (fig. 9) to release the motor.
Geared motor installation part II
34
42
• Insert the rubber needle bearing "28" into its housing in the crown
wheel "27". Fit the first half crown wheel "27" to the geared motor
and rotate it until it reaches position "43" as shown in fig. 11.
10
Fig. 8
Fig. 9
40
38
32
40
39
Fig. 10
28
27
Fig. 11
43
Publicité
Table des Matières
