Service Indicator; Speed Settings; Accessory Tools; Accessories - Hilti DD 30-W Mode D'emploi Original

3.9

Service indicator

LED display / operating status
Lights red / the machine runs.
Lights red / the machine doesn't
run.
Blinks red
3.10 Drilling performance indicator
LED display
Orange
Green
Red
3.11

Speed settings

The machine has two speeds: low speed for starting holes and high speed for normal drilling.
When the control switch is pressed only half way, only the low-speed hole-starting mode is active. The
water flow rate should also be set while the machine is running at this speed. Maximum drilling speed for the
selected speed setting will be reached when the control switch is pressed in all the way.
3.12 Items supplied
machine with side handle, chuck and operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.13

Accessory tools

Designation
Diamond core bit
Core breaking tool
3.14

Accessories

Designation
Drill stand
Core bits
Accessory set for fastening the drill stand with an
anchor
Depth gauge for the drill stand
Spray guard
4

Technical data

4.1 Diamond coring machine
When powered by a generator or transformer, the generator or transformer's power output must be at
least twice the rated input power shown on the rating plate of the machine. The operating voltage of the
transformer or generator must always be within +5% and -15% of the rated voltage of the machine.
The information given applies to a rated voltage of 120 V. The data may vary in the event of deviations from
the rated voltage and for country-specific versions. Please refer to the machine's type identification plate for
details of its voltage, frequency, current and input power ratings.
8 English
Service status
The carbon brushes are badly worn. When the indicator lights for
the first time the machine may continue to be used for several hours
until it switches itself off automatically. Have the carbon brushes
changed in good time so that the machine is always ready for use.
Have the carbon brushes replaced.
Temporary fault, see "Troubleshooting"
Contact pressure
Too low
Optimal
Too high
Designation
DD­C
DD­CB
Designation
DD­ST 30
DD-C, 8 ‒ 35 mm diameter
DD M12 S
DD-ST 30-ES
DD-30-W-CV
2048398
*2048398*