Setting Ring For Torque; Belt Clip; Led; Overload Protection - TOOLCRAFT 1414013 Mode D'emploi Original

f) Setting Ring for Torque
Turning the torque setting ring (2) permits setting of the desired torque from which on-
wards the slip clutch will engage. This will prevent over-turning, e.g. when turning in a
screw. The screw will end flush with the material surface when the torque setting is cho-
sen accordingly.
The torque setting ring has 19 different positions. In 18 of them, the slip clutch is active;
in the position of the drill symbol, the slip clutch is deactivated (ideal for drilling holes).
Low setting: Soft materials, small screws
High setting: Hard materials, large screws
Drill symbol Slip clutch off
When turning out screws, a higher setting or the „drill" setting (drill symbol)
should be chosen.
g) Belt Clip
The cordless screw driller can be attached to a suitable belt using the belt clip during work
breaks or for transport.
If desired, the belt clip can be attached to the left (A) or right (B) side of the cordless screw
driller. You can also remove the belt clip entirely.
Never use the belt clip with high-quality and expensive belts. The metal edges
of the belt clip may cause scratches or damage to the belt.
h) LED
When the on/off switch (9) is pushed, the LED (10) will be activated automatically to
permit lighting of the working position.
If this LED flashes and the drive stops, the rechargeable battery is flat and must be re-
charged.
i) Overload Protection
The motor will stop at overload. Switch off the cordless screw driller and wait until the device has cooled off sufficiently
before using it again.
When the internal rechargeable battery temperature of +75 °C is exceeded, the electronic system will switch off the
power tool. Switch off the cordless screw driller and wait until the device has cooled off sufficiently before using it
again.
33