Charging The Rechargeable Battery - TOOLCRAFT 1414013 Mode D'emploi Original

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7. Charging the Rechargeable Battery

Observe Chapter „Safety Information".
The rechargeable battery must be charged when the drive only turns very slowly without load or when the drive stops
and the LED (10) flashes.
Also charge the rechargeable battery every 3 months if you do not need the cordless screw driller. Otherwise, there
may be deep discharge, which will permanently damage the rechargeable battery.
The rechargeable battery is discharged when the product is delivered and must be charged at initial com-
missioning.
Proceed as follows for recharging the rechargeable battery:
• Connect the charger to the mains voltage. The green LED will light up.
• Remove the rechargeable battery from the cordless screw driller. For this, keep the unlocking button (8) pushed and
pull out the rechargeable battery forwards.
• Push the rechargeable battery into the corresponding insert of the charger in the proper alignment (only one is pos-
sible) (do not apply any force!). Charging will start automatically when the charger has recognised the rechargeable
battery. The green LED goes out and the red charging LED remains lit.
When the green LED flashes, the overtemperature protection has been tripped. Remove the rechargeable
battery from the charger and disconnect the charger from the mains voltage. Let the rechargeable battery
and the charger cool down completely. Start charging anew then.
When the red LED flashes, the charger has recognised the rechargeable battery as defective. Remove
the rechargeable battery from the charger and disconnect the charger from the mains voltage. Check the
connection contacts of the rechargeable battery and the charger and then restart charging. If the red LED
flashes again, the rechargeable battery is defective and must be replaced.
• When the rechargeable battery is fully charged, the red charging LED goes out and the green LED lights up (rechar-
geable battery is fully charged). Depending on the rechargeable battery's condition, the charging duration is approx.
1 hour.
• Remove the rechargeable battery from the charger right after the end of charging.
• Then remove the charger from the mains voltage by pulling the mains plug out of the mains socket.
• Put the rotating direction switch (4) in the middle position to block the drive.
• Push the rechargeable battery into the cordless screw driller until it latches.
30

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1414014

Table des Matières