Operation Of The Cordless Screw Driller - TOOLCRAFT 1414013 Mode D'emploi Original

• When the rechargeable battery is charged, take it out of the charger and then disconnect the charger
from the mains voltage.
• Do not charge the rechargeable battery while it is still hot (e.g. due to operation in the cordless screw
driller). Allow the battery to cool down to room temperature before charging it again.
• Never charge a damaged, leaked or deformed rechargeable battery. This can result in a fire or explosi-
on! Dispose of such unusable rechargeable batteries in an environmentally compatible fashion. Do not
continue to use them.
• Recharge the rechargeable battery about every 3 months, as otherwise they might be fully discharged
due to self-discharge, which renders the rechargeable battery useless.
• Use only the replacement rechargeable battery provided by the manufacturer to replace the recharge-
able battery for the cordless screw driller with. The cordless screw driller may be damaged by using
different rechargeable batteries; there also is a danger of fire and explosion due to an unsuitable rechar-
geable battery.
d) Operation of the Cordless Screw Driller
• Keep your workplace clean. Ensure good lighting at the workplace. Disorder at the workplace or bad
lighting may cause accidents. Keep children away from the working area! Ensure good ventilation of the
workplace.
• Only operate the product when your ability to react is unrestricted. Fatigue or the influence of alcohol or
medication can lead to accidents and injury.
• Rotating parts may wind up hair or items of clothing, danger of injury! Therefore, wear, e.g., a hair net if
you have long hair, and wear close-fitting clothes when working.
• Never touch the rotating drill chucks; never reach into the turning drill. Risk of injury!
• Check the cordless screw driller and the rechargeable battery inserted for damage before any use. If you
find any damage, do not take the device into operation, but have it checked by a specialist.
• The rotating direction switch must be put into the middle position for reasons of safety before inserting or
removing drills or bits. The drive will be blocked in this position (activation lock).
• Use the cordless screw driller only for turning in and out screws, drilling holes or similar work. The
cordless screw driller must not be used for any other purposes (such as mixing of mortar, driving other
devices/machines/tools, etc.).
• Secure the workpiece against slipping or twisting. Use, e.g., a vice for drilling.
• Ensure safe stance when working; use, e.g., a suitable, strong ladder.
• Ensure that no power, gas or water lines are damaged when drilling or turning in screws! With power
lines, there is a danger to life from electrical shock; with gas lines, there is a danger of fire and explosion!
Water lines may also lead to high property damage.
27