Slider For Two-Speed Gear; On/Off Switch With Rotating Speed Control - TOOLCRAFT 1414013 Mode D'emploi Original

d) Slider for Two-Speed Gear
At the top of the cordless screw driller, there is a slider (3) for selection of the two speeds
of the integrated two-speed gear.
A 1st gear, low speed (0 - 350 rpm), high torque
B 2nd gear, high speed (0 - 1350 rpm), low torque
The slider for selection of the two gears must only be actuated when the drive
of the cordless screw driller has stopped completely! Otherwise, the drive may
be damaged.
If one of the gears cannot be engaged when the slider is pushed, the drive
sprockets may be placed badly towards each other.
In this case, push the on/off switch slightly so that the sprockets will move a
little way. Then you should be able to use the slider.
e) On/Off Switch with Rotating Speed Control
In order to operate the on/off switch (9), the rotating direction switch (4) must
not be in the middle position (in this position, the on/off switch is blocked!).
The rotating speed of the drive depends on how far the on/off switch (9) is pushed in (B).
This permits smooth adjustment of the speed from standstill to maximum speed.
When releasing (A) the on/off switch, the drive will be braked to the stop („rotating stop").
When the on/off switch (9) is pushed, the LED (10) will be activated automati-
cally to permit lighting of the working position.
If this LED flashes and the drive stops, the rechargeable battery is flat and
must be recharged.
At tool change, maintenance or cleaning, as well as during transport or sto-
rage, the on/off switch must be blocked with the rotating direction switch (4) for
reasons of safety. There is a danger of injury in case of accidental actuation of
the on/off switch!
32