TOOLCRAFT 1414013 Mode D'emploi Original page 28

• Never work on live parts. When working near any electrical lines or similar, always ensure suitable
contact protection.
• Never overload any electrical devices. Use electrical devices only for the work that they are intended for.
For example, the cordless screw driller must not be used to mix mortar.
• Never stress the cordless screw driller to where the drive stops. This may damage the motor and the
gear both. Blocking of the drive will also lead to very high currents, so that the rechargeable battery and
the power electronics in the cordless screw driller will be overloaded.
• Never push any objects into the ventilation openings of the cordless screw driller. Also ensure that no
drilling dust or metal chips can enter the ventilation openings. This may lead to short circuit and there is
a danger of fire and explosion from the rechargeable battery!
• Depending on the work for which the cordless screw driller is used, wear safety goggles, a dust mask
and hearing protection; if required, also wear a safety helmet (e.g. when working overhead). Otherwise,
there are various dangers of injury!
• Dusts from various materials may be hazardous to health and may cause allergic reactions, diseases of
the respiratory system or even cancer (e.g. asbestos-containing material - this must only be processed/
used by specialists).
• Observe the provisions valid in your country, e.g. on work protection measures.
• Properly hold the cordless screw driller. A sudden stop of the drive (e.g. if a drill catches) will transfer the
torque to the cordless screw driller itself, and it will turn sideways. This poses the danger of the cordless
screw driller falling from your hands, danger of injury!
Switch off the cordless screw driller at once when the drive blocks (e.g. when a drill cants in a workpiece).
• Before you put down the cordless screw driller or set it down onto a surface, wait for the drive to stop
completely.
• The cordless screw driller has a bright LED light that is activated automatically when the on/off switch is
activated.
Attention, LED-light. Never look into the LED beam! Never watch directly or with optical instruments!
Danger of eye damage!
28