Operation; Removing The Rechargeable Battery From The Cordless Screw Driller/Inserting It; Inserting Tool Into The Quick-Action Drill Chuck/Removing It; Rotating Direction Switch (With Activation Lock) - TOOLCRAFT 1414013 Mode D'emploi Original

8. Operation

a) Removing the Rechargeable Battery from the Cordless Screw Driller/Inser-
ting It
• To remove the rechargeable battery from the cordless screw driller, keep the unlocking button (8) pushed; pull the
rechargeable battery out forward.
• To insert the rechargeable battery, push it into the rechargeable battery holder in the correct alignment until it lat-
ches.
b) Inserting Tool into the Quick-Action Drill Chuck/Removing It
• Put the rotating direction switch (4) in the middle position to block the on/off switch (9).
• Open the quick-action drill chuck by turning it counter-clockwise to the left (viewed from
the front) (A).
• Insert the desired tool (in the figure: a cross-recess bit) into the drill chuck. The diame-
ter must be at least 1 mm, and at most 10 mm.
• Tighten the quick-action drill chuck by turning it clockwise to the right (viewed from the
front) (B).
To fasten the tool (e.g. a drill) firmly in the quick-action drill chuck, it should be
inserted at least 1 cm deep (e.g. small drills). Drills with a larger diameter
should be inserted more deeply into the quick-action drill chuck so that they
can be fastened securely.
c) Rotating Direction Switch (with Activation Lock)
The rotating direction switch (4) can be used to switch the rotating direction between left
and right.
A double arrow on the rotating direction switch (on the left (A) and right (not illustrated)
sides on the cordless screw driller) indicates the rotating direction:
Rotating direction counter-clockwise to the left (viewed from behind), to re-
D D
lease screws
Rotating direction clockwise to the right (viewed from behind) to tighten screws
G G
or drilling holes
The rotating direction must be chosen depending on whether holes are to be
drilled or whether a screw is to be turned in or out.
In the middle position, the rotating direction switch will block the on/off switch and thus the
motor in the cordless screw driller.
At tool change, maintenance or cleaning, as well as during transport or sto-
rage, the on/off switch must be blocked with the rotating direction switch (4) for
reasons of safety. There is a danger of injury in case of accidental actuation of
the on/off switch!
Switch the rotating direction only when the drive of the cordless screw driller
has stopped completely! Otherwise, the drive may be damaged.
31