HumanTechnik Radiorécepteur portable radio-lisa Mode D'emploi page 20

2. Setting the correct radio channel
A digital transmission process ensures that the
radio signals are received without errors.
This process also makes it possible to set 10
different radio channels. All RF lisa dvices are
set to channel 0 by default.
It is only necessary to set your system to ano-
ther channel if you have several different users
operating lisa units in proximity.
Set the required channel by using a small
screwdriver to turn the channel selector switch,
which is located on the right of the receiver,
to the required channel number. Use a small
screwdriver to adjust this switch.
All transmitters and receivers must be set to the
same channel.
Fig.: setting the correct radio channel.
Operation
1. Switching the receiver on
Slide the on/off- switch to »on«. The portable
RF receiver is now ready to operate. After the
20 English