Metabo HPT C 12LDH Instructions De Sécurité Et Mode D'emploi page 24

English
2. Inspecting the lever
If the M8 hexagonal head bolts (2) are loose, align the sides of the fence and saw blade with the steel square.
After adjusting the saw blade and fence to a ninety-degree angle, tighten the lever securing hexagonal head
bolts (2).
Hex. head bolt (2)
3. Inspecting the carbon brushes (Fig. 47 and Fig. 48)
The carbon brushes in the motor are expendable parts.
If the carbon brushes become excessively worn, motor trouble might occur.
Therefore, inspect the carbon brushes periodically and replace them when they have become worn to the
wear limit line as shown in Fig. 47.
Also, keep the carbon brushes clean so that they will slide smoothly within the brush holders.
The carbon brushes can easily be removed after removal of the brush caps (see Fig. 48) with a slotted (minus)
screwdriver.
1/4" (6mm)
11/16" (17mm)
4. About Handling the Motor (see Fig. 1)
Winding of the motor is said to be the heart of this tool. Exercise utmost caution not to damage the winding by
exposing it to wash oil or water.
NOTE:
Accumulation of dust and the like inside the motor can result in a malfunction.
After using the motor for 50 hours or so, carry out no-load running, and blow in the dry air
from a wind hole at the motor's rear. Such action is eff ective to discharge dust and the like.
5. Inspecting the screws
Regularly inspect each component of the power tool for looseness.
Re-tighten screws on any loose part.
WARNING:
6. Inspecting the lower guard for proper operation
Before each use of the tool, test the lower guard (see Fig. 7) to assure that it is in good condition and that it
moves smoothly.
Never use the tool unless the lower guard operates properly and it is in good mechanical condition.
7. Storage
After operation of the tool has been completed, check that the following has been performed:
(1) Trigger switch is in OFF position,
(2) Power plug has been removed from the receptacle,
(3) To prevent unauthorized operation of this tool, insert a padlock through the hole in the switch trigger.
When the tool is not in use, keep it stored in a dry place out of the reach of children.
24
Lever
Fig. 46-a
Wear limit line
38
No. 38 indicates the last
two numbers of carbon
brush Code No.
Fig. 47
To prevent personal injury, never operate the power tool if any components are
loose.
Saw blade
Fence
Steel square
Fig. 46-b
Brush cap
Groove for driver
Fig. 48