Metabo HPT C 12LDH Instructions De Sécurité Et Mode D'emploi page 18

English
WARNING:
6. Bevel angle fi ne adjustment
Handle
(1) Grip the handle on the motor head and position it at the bevel angle you need. Temporarily tighten the
clamp lever.
CAUTION:
(2) Make fi ne adjustments to the bevel angle by gripping the handle and moving the knob (A).
NOTE:
Turning knob (A) clockwise, allows fi ne adjustment of the main unit to the left (as seen from
front).
Turning knob (A) counterclockwise, allows fi ne adjustment of the main unit to the right (as
seen from front).
If you wish to cut left bevel angle 48° or right bevel angle 48°, pull the bevel plate backwards
until the hinge contacts either the 8mm bolt (A) or the 8mm bolt (B) then cut diagonally left
or right. Setting to cut left bevel angle 48° or right bevel angle 48° can be done easily.
(3) After adjusting to the desired angle, tighten the clamp lever and clamp the motor head.
CAUTION
7. Compound cutting procedures
Compound cutting can be performed by following the instructions in 4 and 5 above. For maximum dimensions
for compound cutting, refer to "SPECIFICATIONS" table on page 8.
CAUTION:
18
When the workpiece is secured on the left or right side of the blade, the short cut-
off portion will come to rest on the right or left side of the saw blade. Always turn
the power off and let the saw blade stop completely before raising the handle from
the workpiece.
If the handle is raised while the saw blade is still rotating, the cut-off piece may
become jammed against the saw blade causing fragments to scatter about
dangerously.
When stopping the bevel cutting operation halfway, start cutting after pulling back
the motor head to the initial position.
Starting from halfway, without pulling back, causes the lower guard to be caught in
the cutting groove of the workpiece and to contact the saw blade.
Knob (A)
Clamp
lever
8 mm bolt (B)
Fig. 29
If not tightened fi rmly enough the motor head might suddenly move or slip, causing
injuries. Be sure to tighten the motor head section enough so it will not move.
: Always check that the clamp lever is secured and the motor head is clamped. If you
attempt angle cutting without clamping the motor head, then the motor head might
shift unexpectedly causing injuries.
Always secure the workpiece with the right hand side for compound cutting. Never
rotate the table to the right for compound cutting, because the saw blade might then
contact the clamp or vise that secures the workpiece, and cause personal injury or
damage.
Right bevel angle
Knob (A)
Clamp lever
Pull
Bevel plate
Fig. 30
Hinge
Left bevel angle
8 mm bolt (A)