Alecto DVM-350 Mode D'emploi page 49

Battery:
1. Open the battery
ly
2. Insert the battery.
side 3. Replace the battery
t at Never forcibly insert the battery.
Only use the supplied rechargeable Li-ion battery.
tape
Power adapter:
1. Connect the other power adapter to the DC5.9V input on the side of the parent
n the
2. Insert the adapter into a 230V wall socket.
Only use the supplied power adapter.
Make sure nobody can trip or fall over the adapter cable. You can bundle cables
cm that are too long with tape or cables ties available specifically for this purpose.
wall for
Charging:
e The battery will be charged as soon as you connect the power adapter and insert
it into a 230V wall socket.
•
•
m your
e, free •
Table support:
The table support is located at the rear of the parent unit.
ry or Unfold it to place the parent unit on a table or cabinet.
it will
DVM-350-manual-NL-FR-D-GB-v1.0.indd 49
compartment by un-
screwing the battery
cover on the rear of
the parent unit.
cover onto the pa-
rent unit and tighten
the screw.
unit.
For initial use, charge the battery for at least 15 hours, even if the indicator
shows a fully charged battery.
The charging circuit for the battery is managed electronically and there is no
risk of overcharging, this allows you to leave the adapter connected at all
times.
In case you will not use the set for a longer period of time (>2 months), please
make sure to disconnect the adapter from the wall socket and remove the
battery from the parent unit. When starting to use the set again, make sure to
properly charge the battery.
49
22-3-2016 15:01:55