Installation Baby Unit; Parent Unit - Alecto DVM-350 Mode D'emploi

3 INSTALLATION
3.1 BABY UNIT: (CAMERA)
Power adapter:
1. Connect one of the included power adapters to the DC5.9V input on the side
2. Insert the adapter into a 230V wall socket.
Only use the supplied power adapter.
Make sure the baby cannot touch the baby unit or cable. Keep the baby unit at
least 2 meters away from the baby and bundle cables that are too long with tape
or cable ties specifically for this purpose.
Table model or wall model:
You can place the baby unit on a table, cabinet or desk or you can hang it on the
wall.
In case of wall mounting:
Drill two holes next to each other in the wall separated by a distance of 4,8 cm
and insert plugs and screws. The head of the screw should stick out of the wall for
several millimeters.
Suspend the baby unit by sliding the notches in the camera support over the
screws in the wall and pushing the baby unit a little downwards.
Finally, use cable clips to neatly tuck away the adapter cable.
Tips for placement:
• For use as a baby monitor: place the baby unit at least 2 meters away from your
baby and make sure to safely tuck away the adapter cable.
• For optimal range, it is advisable to set up the baby unit as high as possible, free
from large metal surfaces.

3.2 PARENT UNIT:

The parent unit is not waterproof and therefore only suitable for indoor use.
Power supply:
The parent unit can be powered directly by the included rechargeable battery or
via the supplied power adapter. As soon as you connect the power adapter, it will
charge the battery allowing for mobile use of the parent unit.
48
DVM-350-manual-NL-FR-D-GB-v1.0.indd 48
The baby and parent units are not waterproof, therefore they are only
suitable for indoor use.
of the baby unit.
Ba
1.
2.
3.
Ne
On
Po
1.
2.
On
Ma
tha
Ch
Th
it i
•
•
•
Ta
Th
Un
22-3-2016 15:01:55