Installation; Tools And Equipment; Removing The Protective Film; Preparation For Circulating Air Mode - baumarkt TC50A Mode D'emploi

Installation

A certain amount of manual dexterity is required for installation. Observe the

Tools and equipment

previously mentioned sequence of installation steps.
Before beginning, have the following equipment available:
– Phillips screwdriver, size 2
– Drill with drill bits: stone ø 6 and 8 mm, wood ø 3 mm
– Wallplugs and screws
– Measuring tape/folding ruler
– Spirit level
– Pencil
– Stable ladder
– Air hose, ø 12.5 cm, for extraction mode, or activated carbon filter for
circulating air mode
Some tasks for the installation will be made much easier if a second
Important!
person is available to assist in passing the tools and to hold the
components.
The surfaces of your new extraction hood may be covered with films to protect

Removing the protective film

them from being scratched during transport. Only remove the protective films
immediately before final attachment of the extraction hood.
Observe that the appliance can have sharp edges on the inside.
Risk of injury!
1. Press inwards the side sliding levers 12 on the underside of the hood
Preparation for cirgulating air mode
and open the filter flap.
2. Set the lever 13 for redirecting the air to 2 and affix the lever.
3. Install the covers 3 in the upper air discharge aperture in the extraction
hood.
10
13
Preparation
12
3