Mtg D, Mtw D, Mhp D - General; Up/Down Function; Jobmaster Function - Fronius MTG 250d Instructions De Service

MTG d, MTW d, MHP d - General

Up/Down func-
tion
JobMaster func-
IMPORTANT!
tion
Coded messages can appear on the JobMaster.
These correspond to the service code displayed on the control panel at the same time
(see the "Troubleshooting" section of the power source operating instructions).
SynchroPulse (option) - no symbol lights up on the JobMaster (see the "MIG/MAG wel-
ding" section of the power source operating instructions).
1
40
- Select one of the following parameters
on the power source:
• Wire feed speed
• Job number
- Set the parameters using the Up/
Down function
IMPORTANT!
In the "MIG/MAG Standard Synergic
and Pulse Synergic Welding" operating
modes, extra parameters can be set.
2