ENGLISH
adJUsting tHe internal temperatUre
Frigolatte WitH mecHanical tHermostat
The refrigerator temperature can be regulated by adjusting the thermostat knob.
Turn it clockwise to reduce the temperature.
Frigolatte WitH electronic tHermostat
Display
The display has three digits with seven segments and shows the temperature measured by the sensor, while
when an alarm is activated the messages shown in the "fault signal" table are displayed.
The meaning of the light points in the display is as follows: The number 3 on the left flashes during the setting
phase. The number 1 on the right switches on when the main (compressor) relay switches on.
How to view and edit the set point
1) Hold "↵" down for 3 sec, and SEt appears.
2) Press "↵" to view the Set Point and edit the value using "▲" or "▼".
3) Press "↵" to confirm the new setting, after 10 sec the controller exits the programming mode and the
settings are stored in the memory.
CAUTION: Do not switch off the instrument before it has exited programming mode and the new settings
have been saved.
Note: The Set Point value can be edited only within the range defined by "Los" and "His".
Editing configuration parameters
1) Press "↵" and hold it down for 10 seconds, the first parameter ("HyS") will appear on the display.
2) Press "▲" or "▼" to select the parameter to be edited.
3) Having selected the relevant parameter, press to view the current value and then edit using the keys.
4) Press to confirm the new value. After 10 sec the controller exits the programming mode and the settings
are stored in the memory.
Locking the keypad
To lock and unlock the keypad, hold "↵" and "▼" down together for 10 seconds.
The codes that are displayed for 1 second are: "Pof" when the keypad is locked and "Pon" when the
keypad is active.
When the keypad is locked only the "Set" parameter can be edited.
10
FRIGOLATTE FL 11 - BACK C
FRIGOLATTE FL 11 - BACK C 00_29-05-2015