Pentair Flotec FP 7K Manuel D'utilisation Et D'entretien page 11

EN
USE AND MAINTENANCE MANUAL
CHAPTER 3
INSTALLATION (SEE FIG. 1)
DANGER - ELECTRIC SHOCK RISK
When installing, please ensure electropump is disconnected from electrical supply. Pumps in this
series are not suitable for use in a swimming pool and the relevant cleaning and servicing operations.
DANGER
To prevent possible injuries to people, avoid inserting hands into the mouth of the pump if this is connected
to the mains.
DANGER
This appliance can be used by children aged 8 years or over and by persons with limited physical, sensory
or intellectual capabilities, or with limited experience and knowledge, provided that they are supervised or
have been instructed in the safe use of the appliance and are aware of the dangers involved. Children must
not be allowed to play with the appliance. Cleaning and user maintenance must not be carried out by children
unless they are supervised
WARNING
Pollution of the liquid could occur due to the leakage of lubricants
Use the handle provided to transport or lift the pump.
To use the pump in permanent installations with rigid pipes, to install a check valve to avoid the fluid being re-circu-
lated once the pump is stopped. The installation of a quick closing fitting in a convenient position facilitates cleaning
and maintenance operations. The dimensions of the collection container should reduce to the minimum the number
of starts per hour (see LIMITATIONS - Technical data). To use the pump for temporary applications, install a flexible
pipe and connect it to the pump using a pipe holder. To immerse the pump, use a rope and fix it to the handle.
The automatic PENTAIR FLOTEC VIP/FP model is equipped with a pre-set float switch (See fig.1) please increase or
decrease the free piece of float switch cable by making it sliding through the proper seat on the handlebar, when
modifyng the rating of float switch. There can be particular requirements for pumps used in or next to pools, garden
ponds or similar places.
WARNING
Verify that the floating switch stops the pump as soon as the minimum level is reached.
WARNING
Make sure that the floating switch is free to move. (see also Fig. 7 and 8)
The pumps used in ponds, small lakes, fountains or similar installations or close to them should have a cut-out
switch. Contact a specialised electrician.
PUMP ANCHORAGE
Use the slots on the filter cap (see Fig. 2, pos. 1) to anchor the pump. Then, remove the inserts from the filter cap. It
is also possible to insert 3 screws in the widest section of the slots (see Fig. 2, pos. 2) and turn the filter cap counter-
clockwise so that the screws keep the cap in place in the narrowest section of the slots (Fig. 2, pos. 3). After fixing
the filter cap, it is necessary to insert the pump in the related guides (see Fig. 3, pos. 4) and turn it counterclockwise
to fix it in place (Fig. 5).
9