Scope Of Delivery - Benning MM 10–PV Notice D'emploi

For voltage measurements on PV systems with system voltages
of up to 1500 V DC, use the BENNING TA PV measuring adapter
and the switch position "PV" of the BENNING MM 10-PV only.
The measuring adapter reduces the voltage applied to the
BENNING MM 10-PV and is to be used exclusively for the
BENNING MM 10-PV!

Electrical danger!
The measuring adapter BENNING TA PV must be used in elec-
trical circuits of overvoltage category II with a conductor for a
maximum of 1000 V AC/ 1500 V DC to earth, overvoltage cat-
egory III with a conductor for a maximum of 1000 V to earth only
or of overvoltage category IV with a conductor for a maximum
of 600 V to earth only.
In order to prevent any danger, always measure a present volt-

age first without low-pass filter (without high-frequency sup-
pression) to detect a dangerous voltage.
Before starting the multimeter, always check the device as well

as all measuring leads for damages.
If it can be assumed that safe operation is no longer possible, switch the device
off immediately and secure it against unintended operation.
Safe operation can be assumed to be no longer possible, if
- the device or the measuring leads exhibit visible damages,
- the device no longer works,
- the device has been stored under unfavourable conditions for a longer period
of time,
- the device was exposed to extraordinary stress during transport, or
- if the device or the measuring leads are exposed to moisture.
In order to prevent danger
- do not touch the bare contact tips of the measuring leads,

- plug the measuring leads into the correspondingly marked
measuring sockets of the multimeter and check them for
tight fit.
Cleaning:

Regularly wipe the housing by means of a dry cloth and clean-
ing agent. Do not use any polishing agents or solvents!
3.

Scope of delivery

The scope of delivery of the BENNING MM 10-PV/ MM 10-1 comprises:
3.1 One BENNING MM 10-PV/ MM 10-1
3.2 Two safety measuring lead, red/ black (L = 1.4 m) (item no. 044145)
3.3 One compact protection carrying case
3.4 One wire temperature sensor, type K
3.5 Two 1.5 V batteries (type AA/ IEC LR6) for initial assembly is integrated
into the device
3.6 One operating manual
Additional scope of delivery of the BENNING MM 10-PV:
3.7 Two safety crocodile clips, red/ black, 4 mm plug-in technology
3.8 One BENNING TA PV measuring adapter (item no. 10217846)
Note on optional accessory:
- Temperature probe (K-type) made of V4A tube
application: insertion probe for soft-plastic materials, liquids, gas and air
measuring range: - 196 °C up to 800 °C
dimensions: length = 210 mm, tube length = 120 mm, tube diameter = 3 mm,
V4A (item no. 044121)
Parts subject to wear:
- The BENNING MM 10-PV contains fuses for overload protection:
One fuse rated 11 A rapid-acting (1000 V) 30 kA, D = 10 mm, L = 38 mm (item
no. 10218772).
- The BENNING MM 10-1 contains fuses for overload protection:
One fuse rated 440 mA rapid-acting (1000 V) 10 kA, D = 10 mm, L = 34.9 mm
03/ 2020
BENNING MM 10–PV/ MM 10–1

30