Benning MM 10–PV Notice D'emploi page 28

BENNING MM 10-PV/ MM 10-1
TRUE RMS digital multimeter for
- DC/ AC voltage measurements
- DC/ AC current measurements
- resistance measurements
- continuity and diode tests
- capacity measurement
- frequency measurement
- temperature measurement
Table of contents
1. User instructions
2. Safety instructions
3. Scope of delivery
4. Device description
5. Functions of the digital multimeter
5.1 General information
5.2 Data logger functions
5.2.1 Setting the data logger
5.2.2 Automatic storage (LOG)
5.2.3 Manual storage (SAVE)
5.3 Data transmission to the smartphone/ tablet
6. Ambient conditions
7. Electrical specifications
8. Measuring with the BENNING MM 10-PV/ MM 10-1
9. Maintenance
10. Technical data of measuring accessories
11. Environmental note
1. User instructions
This operating manual is intended for
- skilled electricians and
- electrotechnically trained personnel.
The BENNING MM 10-PV/ MM 10-1 is intended for measurements under dry am-
bient conditions. It must not be used in electrical circuits with a nominal voltage
higher than 1000 VAC/DC (see section 6 „Ambient conditions").
When using the BENNING MM 10-PV with the BENNING TA PV measuring
adapter, the nominal voltage range increases to 1500 VAC/ 2000 VDC (see sec-
tion 8.2.2 „Voltage measurement (switch position PV)" and section 10 „Technical
data of measuring accessories" for details).
The following symbols are used in this operating manual and on the BENNING
MM 10-PV/ MM 10-1:
Attention! Magnets might affect the correct functioning of cardiac pace-
makers and implanted defibrillators. As a user of such medical devices,
keep a sufficient distance to the magnet.
Warning of electrical danger!

Indicates instructions which must be followed to avoid danger to per-
sons.
Attention! Must comply with documentation!

This symbol indicates that the information provided in the operating
manual must be complied with in order to avoid risks.
Measuring category II is applicable to testing and measuring circuits
CAT II
which are directly connected to user connections (sockets and similar
connections) of the low-voltage mains installation.
Measuring category III is applicable to testing and measuring circuits
CAT III
connected to the distribution circuit of the low-voltage mains installa-
tion of a building.
Measuring category IV is applicable to testing and measuring circuits
CAT IV
connected to the feed-in point of the low-voltage mains installation of
a building.
03/ 2020
Operating Manual
BENNING MM 10-PV/ MM 10-1

28