Basic Operation - Eschenbach visolux digital XL FHD Mode D'emploi

Basic operation

Before you use the visolux DIGITAL XL FHD for the first time, you must fully charge
the internal battery.
To do this, fit the appropriate country adapter to the power supply. Then plug the
EN
power supply into the mains plug and connect the cable to the USB connection f.
The charging indicator lamp illuminates while the device is being supplied with
power g.
You can use the device while it is charging and it can remain permanently plugged in.
Switching on/off
Press the on/off button r to switch the device on. After a few seconds the camera image
will appear on the display q. Symbols briefly show the current status, e. g., of battery
charging state, zoom factor and display brightness.
Press and hold the On/Off button for r for one second to switch the device off. The cur-
rent settings are saved.
Reading with the device
Unfold the feet h. Switch the device on and place it on the reading material.
If you are using the device with the minimum zoom factor 2× you will see the complete
image section around 12 cm wide on the display. If the zoom is increased, the image sec-
tion will decrease.
On the rear you can relocate the camera position:
Position at bottom = reading mode, position at top = writing mode
Dynamic Line Scrolling (DLS)
Thanks to the scrolling function it is not necessary to move the
device to one side in order to read a complete newspaper column, for example, even at
high zoom factors.
To move the image selection to the right, press the scroll button i (repeated pressing
or keep pressed down).
- 22 -