Gardeo GSEBRTHE18VLI Traduction Des Instructions D'origine page 58

Fault
For Prunner
The Prunner runs but is not cutting
The Prunner will cut only if the speed is
high,result is only chips with several
larger parts.
The Prunner runs slowly and remains
slightly jammed
On the starter being pushed,the motor will
not start
The motor runs but the chain will not run
No oil is supplied to the chain
The chain gets loosen from the guide bar
The unit is smoking
Oil leaking from the unit
For hedge trimmer.
The hedge trimmer runs slowly and
remains slightly jammed
On the starter being pushed,the motor will
not start
The motor runs but the blade not run
The unit is smoking
The blade is so hard to cut the branchs or
find it's smoking.
Page 58 de 65
Cause
The chain is fitted in reverse on the
guide bar
The chain is blunt
Too low voltage
1.The swich fuse was not pushed in to
release the starter
2.The extension cable coupling released
3.Automatic fuse or switch open
4.Warm motor brushes
5.An electric clrcuit on the unit opens
Faulty sprocket wheel
5. Guide bar oil tank plugged
6. Oil too thick
5. Chain slackened
6. Guide bar and chain misassembled
The unit is faulty.Do not use it
Oil tank cover not closed
Too low voltage
1.The swich fuse was not pushed in to
release the starter
2.The extension cable coupling released
3.Automatic fuse or switch open
4.An electric clrcuit on the unit opens
Jammed in the gear box.
The unit is faulty.Do not use it
No lubricationon the blade.
Troubleshooting
Refer to the assembly of guide bar and
chain
Refer to the saw chain sharpening
The extension cable core wire not
dimensioned sufficiently(see Extension
Cables).
1.Push the starter fuse before pushing the
starter
2.Check cable coupling
3.Check automatic fuse or switch
4.Call authorised servicing centre
5.Call authorised servicing centre
Call authorised servicing centre
5. Remove the guide bar and clean the
oil tank
6. Use the righe oil.(see oil tank refill)
5. Tlghten the chain see chain tension
set-up (p.28)
6. see Guide Bar and Chain Installation
Call authorised servicing centre
Tighten the oll tank cover.
Notice:Empty the oil tank while the unit is
out of use
The extension cable core wire not
dimensioned sufficiently(see Extension
Cables).
1.Push the starter fuse before pushing the
starter
2.Check cable coupling
3.Check automatic fuse or switch
4.Call authorised servicing centre
Call authorised servicing center.
Call authorised servicing centre
After each use, clean the blades and
lightly lubricate with general purpose oil or
spray lubricant.