Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Store the battery only within a temperature range
between 0 °C and 50 °C. As an example, do not
leave the battery in the car in summer.
Occasionally clean the venting slots of the
battery using a soft, clean and dry brush.
IMPORTANT SAFETY INSTRUCTIONS FOR
BATTERY CARTRIDGE
1.
Before using battery cartridge, read
all instructions and cautionary markings on
batterycharger, battery, and product using
battery.
2.
Do not disassemble battery cartridge.
3.
If
operating
excessively shorter,
immediately.
It
may result in a risk of
overheating, possible burns and even an
explosion.
4.
If electrolyte gets into your eyes, rinse them
outwith clear water and seek medical attention
rightaway. It may result in loss of your eyesight.
5.
Do not short the battery cartridge:
(1) Do not touch the terminals with any conduc-
tive material.
(2) Avoid storing battery cartridge in a container
with other metal objects such as nails, coins,
etc.(3) Do not expose battery cartridge to
water orrain.
A battery short can cause a large
current flow,overheating, possible burns and
even a break-down.
6.
Do not store the tool and battery
cartridge in locations where the temperature
may reach orexceed 50°C (122°F).
7.
Do not incinerate the battery cartridge even
if itis severely damaged or is completely worn out.
The battery cartridge can explode in a fire.
8.
Be careful not to drop or strike battery.
9.
Do not use a damaged battery.
SAVE THESE INSTRUCTIONS.
Tips for maintaining maximum battery life
1.
Charge the battery cartridge before
completely discharged.
Page 49 de 65
time
has
become
stop
operating
Always stop tool operation and charge the bat-
tery cartridge when you notice less tool power.
2.
Never recharge a fully charged battery
cartridge.
Overcharging shortens the battery service life.
3.
Charge the battery cartridge with room
temperature at 10°C – 40°C (50°F – 104°F).
Let a hot battery cartridge cool down
beforecharging it.
4.
Charge the battery cartridge once in
every six months if you do not use it for a long
period oftime.
FUNCTIONAL DESCRIPTION
Installing or removing battery cartridge
CAUTION:
• Always switch off the tool before installing or
removing the battery cartridge.
• Make sure that you lock the battery cover before
use.
Otherwise, mud, dirt, or water may cause
damage to the product or the battery cartridge.
Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
Protect the battery charger from rain and
moisture. The penetration of water in a battery
charger increases the risk of electric shock.
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one
type of battery, it may create a risk of fire when
used with another battery.
Do not charge other batteries. The battery
charger is suitable only for charging our batteries
within the listed voltage range. Otherwise there is
danger, fire and explosion.
Keep the battery charger clean. Contamination
may cause the danger of electric shock.
Publicité
Table des Matières
