Maytag MEW6627DDS Guide D'utilisation Et D'entretien page 21

Troubleshooting
PROBLEM
Oven baking results are less
than expected.
Baking results differ from
previous oven.
Fan is heard during broiling,
cleaning and some baking
operations.
Cooling fan continues to
operate after the oven has been
turned off.
Fault Codes
There are no beeps and
no display.
Noises may be heard.
SOLUTION
• The pans being used may not be of the size or material recommended for best
results.
• There may not be sufficient room around sides of the pans for proper air circulation
in the oven.
• Check instructions for preheating, rack position and oven temperature.
• Oven thermostat calibration may differ between old and new ovens. Follow recipe
and use the directions in this guide before calling for service since the calibration on
the previous oven may have drifted to a too high or too low setting. (See page 12 -
Adjusting the Oven Temperature.)
• This is the cooling fan and is normal. The fan will continue to run after use
until the oven cools.
• This is normal. The fan will automatically shut off when the oven is cooled.
• The BAKE or LOCK icon may flash rapidly in the display to alert you if there is an error
or a problem. If the BAKE or LOCK icon appears in the display, press CANCEL pad.
If the BAKE or LOCK icon continues to flash, disconnect power to the appliance.
Wait a few minutes, and then reconnect power. If the icon flashing still continues,
disconnect power to the appliance and call an authorized servicer.
• If the oven is heavily soiled, excessive flareups may result in a fault code during
cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
• Oven may be in Sabbath Mode. (See page 11.)
• The oven makes several low level noises. You may hear the oven cooling fan going
on and off. You may also hear the oven relays as they go on and off. These are all
normal.
• As the oven heats and cools, you may hear sounds of metal parts expanding and
contracting. This is normal and will not damage your appliance.