Fault - Angelo Po 090FT1G Manuel D'utilisation Et D'installation

The appliance has been tested before being put
into service. The information provided below is in-
tended to assist in the identification and correction
of any anomalies and malfunctions which might oc-
cur during use.
Faults
Smell of gas
The pilot light
does not ignite
The pilot light goes out
The pilot light ignites but the
burner remains off
The flame is yellow
Burner control knob is stiff
IT
IT
GB GB
DE DE
FR FR
ES ES
English
TROUBLESHOOTING
Occasional leak because flame has
The spark ignition devices are not
Air in pipelines due to long period out
The thermocouple has not warmed
Burner dirty, heat exchange pipes
clogged, condensation drips

FAULT

The user can solve some of these problems him-
self, but for others specific technical knowledge or
skill is required, and so they must only be carried
out by qualified staff with recognised experience ac-
quired in the specific sector of operation.
Causes
gone out
working
of use
up enough
Gas valve malfunction
- 16 -
Remedies
Turn off the gas supply tap and ven-
tilate the room
Check that the ignition devices are in
good working order. Light by hand
with a naked light
Important
Contact the after-sales service
Make more attempts to light the
flame
Make more attempts to light the
flame
Check the condition of the thermo-
stat and activate any ignition ena-
bling device
Important
Contact the after-sales service
Important
Contact the after-sales service
6