Angelo Po 090FT1G Manuel D'utilisation Et D'installation page 37

FITTING THE RESIDUE DRAIN EXTENSION
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Cut off the mains electricity supply using the ap-
pliance's master switch.
3 - Pull off the knob (A).
4 - Undo the screws (B) and remove the control
panel (C).
5 - Fit the residue drain extension(D) into the drain
pipe (E) and secure it with the nut (F).
6 - Replace the control panel (C) and the knobs (A)
on completion of the operation.
FITTING THE DRIP TRAY RUNNER
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Cut off the mains electricity supply using the ap-
pliance's master switch.
Fitting the runner on an enclosed section
3 - Fit the drip tray runner (A) with the screws (B)
and insert the drip tray (C).
Fitting the runner on an open section
4 - Fit the drip tray runner (A) with the screws (B)
and insert the drip tray (C).
A B
B
C
B
B
- 11 -
E
D
IDM-39614702500.tif
A
B
C
IDM-39614702600.tif
A
C
IDM-39614702700.tif
F
IT
GB
DE
FR
ES
English