When Moving Your Beverage Center:
Your beverage center is heavy. When moving the appliance
for cleaning and service, be sure to cover the floor with
cardboard or hardboard to avoid floor damage. Always pull
the appliance straight out when moving it. Do not wiggle or
"walk" the appliance when trying to move it, as floor
damage could occur.
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your beverage center before using it. See the cleaning
instructions in "Beverage Center Care."
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
Reverse Door Swing
(optional)
Tools Needed: Phillips screwdriver
1. Unplug beverage center or disconnect power.
2. Remove the screws from each side of the top of the beverage
center cabinet and set aside.
NOTE: There are seven screws total. Do not discard.
3. Remove the hinge cover and washer and set aside.
Top View
A
A. Top of beverage center cabinet
B. Hinge cover
C. Washer
4. Lift the door straight up and off of the bottom hinge.
5. Remove the screws fastening the bottom hinge and cover to
the bottom of the beverage center cabinet. There are five
screws total.
6. Move the bottom hinge and cover each to the opposite side
of the bottom of the beverage center cabinet. Completely
tighten the five screws.
B
C
Front View
A
A. Cover
B. Bottom of beverage
center cabinet
7. Remove the two screws fastening the door stop spacer and
the door stop to the bottom of the beverage center door.
8. Move the door stop spacer and the door stop to the opposite
side and fasten with the two screws. Completely tighten the
screws.
Bottom View
A. Bottom of beverage center door
B. Door stop spacer
C. Door stop
9. Place the washer onto the bottom hinge, then install the
beverage center door onto the washer and hinge pin.
A
B
A. Bottom hinge washer
B. Bottom hinge
10. Align the top hinge washer with the hinge hole in the top of
the door. Then, insert the top hinge pin through the washer
and into the hinge hole.
11. Fasten the top hinge cover with three screws and move the
remaining four screws to the opposite side. Completely
tighten the seven screws.
A
B
A. Top hinge washer
B. Top hinge
B
C
D
C. Bottom hinge
D. Washer
A
B
C
5