Prune Stations; Operating Your Radio - Fm; Manual Tuning - Fm - PERFECTPRO DABBOX Mode D'emploi

Prune stations

If you move to a different part of the country, some of the stations
which were listed may no longer be available. Also from time to time,
some DAB services may stop broadcasting, or may change location
or frequency. Stations which cannot be found, or which have not been
received for a very long time are shown in the station list with a question
mark. The prune stations function will delete the marked DAB stations
from your station list.
1. Press and hold the Info/Menu button and the display will show "Full
scan".
2. Rotate the Tuning control knob to find "Prune". Press and release
the Tuning control knob to enter adjustment mode. Then rotate the
Tuning control knob to select "Yes" or "No". To activate the Prune
function select "Yes", and press and release the Tuning control knob
to confirm the setting.
3. If you do not wish to prune stations, select "No" and then press and
release the Tuning control knob.
Note:
If you have moved your radio to a different part of the country you
should also carry out a search for new stations (please see the section
'Finding new stations').
Operating your radio – FM
1. Straighten the antenna properly above the radio. Press the Power
On/Off button to switch on your radio.
2. Press the Source button to select FM waveband.
3. To scan up in frequency, first rotate the Tuning control knob in a
clockwise direction and then press the Tuning control knob. Your
12
radio will scan in an upwards direction (low frequency to high
frequency) and stop automatically when it finds a station of sufficient
strength. To scan down in frequency, first rotate the Tuning control
knob in a anti-clockwise direction and then press the Tuning control
knob. Your radio will scan in a downwards direction and stop
automatically when it finds a station of sufficient strength. After a few
seconds the display will update. The display will show the frequency
of the signal found. If the signal is strong enough and there is RDS
data present then the radio will display the station name.
4. When the waveband end is reached, your radio will recommence
tuning from the opposite waveband end.
5. Adjust the Volume control to the required setting.
6. To switch off your radio, press the Power On/Off button.
Manual tuning – FM
1. Press the Power On/Off button to switch on your radio.
2. Press the Source button to select FM waveband.
3. Rotate the Tuning control knob to tune to a station. The frequency will
change in steps of 50 kHz. When the waveband end is reached, the
radio will recommence tuning from the opposite waveband end.
4. Set the Volume Control to the required setting. To switch off your
radio, press the Power On/Off button.