Lighting; Burning Wood (Tai M) - Dovre TAI 45M Installation Et Mode D'emploi

Anthracite coal
Anthracite coal is divided into various categories on
the basis of characteristics, sometimes specified by
law, such as the percentage of volatile compounds.
The ash content of anthracite coal is between 3% and
13%. The lower the ash content, the higher the net
heating value and the less often you have to remove
ash.
Preferably use category A anthracite coal with a
low ash content.
Use the recommended size 12/22 or 20/30.
For lighting the fireplace, follow the instructions in
the "Lighting" paragraph.

Lighting

You can check whether the flue has sufficient draught
by lighting a ball of paper above the baffle plate. A cold
flue often has insufficient draught and consequently,
some smoke may escape into the room instead of up
the chimney. You can avoid this problem by lighting
the fire as described below.
1. Stack two layers of medium sized logs crosswise.
2. Stack two layers of kindling crosswise on top of
the logs.
3. Place a firelighter cube in the lower layer of kind-
ling and light the cube according to the instructions
on the packaging.
Subject to change because of technical improvements
4. Close the door of the appliance and open the
primary and secondary air inlets by completely
opening the primary and secondary air sliders; see
the following figure. If there is inadequate draw,
the ash pan can be set at a small tilt for some
time.
5. Let the fire develop into a good blaze until there is
glowing bed of charcoal. After this, you can add
more fuel and adjust the appliance; see the sec-
tions on "Burning wood", "Burning brown coal bri-
quettes (for TAI M only)" and "Burning anthracite
coals (for TAI M and TAI C)" .
= Open
o

Burning wood (TAI M)

After you have followed the instructions for lighting:
1. Slowly open the door of the appliance.
2. Spread the charcoal evenly across the bottom of
the stove base.
3. Stack a few logs on the charcoal.
09-20020-355
= Closed
l
17