Publicité
Les langues disponibles
Les langues disponibles
Adjusting the transmission frequency
Adjust the desired transmission frequency with switch
switch corresponds to a transmission frequency. The transmission frequencies are
listed on the type plate in the battery compartment.
Make sure that transmitter and receiver operate on
the same frequency.
Use a small screwdriver (width approx. 2 mm) for switching.
Switching the transmitter on / selecting the sensitivity
The ON/OFF switch
As the ON/OFF switch is used more often it is set slightly higher
than the sensitivity switch.
After switching on the transmitter you have to wait approx. 2 seconds as the
transmitter requires this time for adjusting to the chosen frequency (PLL locked).
After a short time, the red LED below the ON/OFF switch will light up. It serves
as a pilot lamp and indicates:
when it is lit:
when it blinks:
if it flickers:
and the sensitivity switch
The battery is O.K.
The battery is almost flat, it will only work for about another
half an hour.
A self-test has shown a defect. Please return the microphone
to your local Sennheiser service department for repair.
LED
. Each number on the
are recessed.
15
Publicité
