CombiSteel 7455 Série Mode D'emploi page 11

Faults
Fault Symptom
Appliance does not Green switch light & orange lamp
do anything do not light
Green switch light & orange lamp
Appliance
do not light
remains cold
Appliance
remains cold
Green switch light & orange lamp
light
Appliance does not
reach the set
temperature
/ Long frying time
/ too high
temperature
If after these controls, the malfunctioning continues, it is advisable to contact your supplier for
assistance. In case of any doubt, always contact your supplier!
1) Reset overload circuit breaker
- Allow the deep fryer to cool down.
- Remove the detachable control panel from the support.
- Unscrew the black protective cap from the bottom of the detachable control panel.
- Press the "reset button" of the overload circuit breaker. You should hear a clear click.
- Screw the black protective cap back on.
- Reinstall the detachable control panel on the support.
Warranty
Any defect affecting the functionality of the appliance that becomes apparent within one year after purchase will
be corrected by free repair or replacement provided the appliance has been used and maintained in accordance
with the instructions and has not been abused or misused in any way. Your statutory rights are not affected. If
the appliance is claimed under warranty, state where and when it was bought and include proof of purchase (f.e.
receipt).
In line with our policy of continuous product development we reserve the right to change the product,
packaging and documentation specifications without notice.
Discarding & Environment
At the end of the life of the appliance, please dispose of the appliance according to the regulations and
guidelines applicable at the time.
Throw packing materials like plastic and boxes in the appropriate containers. Used frying oils and fat
dispose according to legal regulations and guidelines.
Manual fryer
Possible cause
No mains voltage
Switch is off
Check if the thermostat is
on
Thermostat defective
Detachable control panel
is not correctly
positioned on the
support
Overload circuit
breaker tripped.
Micro switch defective
Overload circuit
breaker defective
Thermostat defective
11
Possible solution
Check the electrical
installation.
Turn on the switch
Switch defective
Turn on the thermostat
Contact your supplier
Install the detachable control
panel correct on the support.
See Installation.
Reset the overload circuit
breaker. See note 1)
Contact your supplier
Contact your supplier
Contact your supplier
CombiSteel