EUROM Sub-heat 1500 Manuel D'utilisation page 19


As soon as the space has reached the required temperature, turn back the
temperature knob slowly until you hear a click. The heater will switch off and the
check light will go out. The temperature has now been set and the heater will
retain this by switching on and off intermittently.

You can activate the oscillation function by setting the oscillation switch to I, you
can switch it off again by setting it to O.

To switch the heater off, you must first switch off the oscillation function and then
set the control knob to 'O' (off). Make sure that you then remove the plug from the
socket.
Sub-heat 2000:
Set the main switch to I (on).

Pressing the on/off switch a will activate the ventilator. The ventilator symbol and
the current temperature will appear on the display.

With the buttons b (higher) and c (lower) you can now set the required
temperature, to max. 35°C. If the set temperature is higher than the current
temperature, then the heater will start operating. Symbol d will then light up: the
heater is working at half power. If you set the temperature to a much higher value
than the current temperature, then a second d symbol will light up: the heater is
working at full power. Once display has shown the set temperature for a few
seconds, then it will return to the current temperature.

You can also switch the heating on using button d instead of the buttons b & c
(so without setting the thermostat, continuous operation). Pressing 1x is half
power, pressing 2x is full power and pressing 3x is return to ventilation.

You can activate the oscillation using button e.
Pressing this button again will switch this function
off.

You can set the timer using button f. Each time you
press it gives an extra hour of operation, up to a
max. of 8 hours.

To switch the heater off, press button a. All
functions will be switched off except the ventilator.
Allow this to rotate for 30 seconds for cooling and
then switch the heater off using the main switch.
Finally remove the plug from the socket.
You can also use the remote control for operating the
heater, it has the same buttons as the control panel on the appliance, see fig.
Safety features
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
19