EUROM Sub-heat 1500 Manuel D'utilisation page 18

Description

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.

Choose a suitable location for the heater which is at least one metre away from
any obstructions, walls or inflammable materials (see also safety instructions).

Make sure a functioning heater is always placed on a solid, flat and horizontal
surface.

Check that the control knob (Sub-heat 1500) / main switch (Sub-heat 2000) is set
to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V socket. To prevent
the circuit overloading, check that no other appliances are connected to the same
group. Only connect the heater to an earthed socket!
Set-up and Operation

Turn the thermostat knob to maximum (as far as possible in the clockwise
direction)

Operate the heater by turning the control knob to one of the three settings: 500,
1000 or 1500 Watts. The check light will now burn.
Sub-heat 1500:
A. Control knob
B. Thermostat knob
C. Check light
D. Oscillation switch (rear)
E. Air discharge grille
F. Oscillating foot
Sub-heat 2000:
1. Control buttons
2. Grip (rear)
3. Main switch with check light (rear)
4. Display
5. Air discharge grille
6. Oscillating foot
7. Remote control
Location and Connection
18