Communication Amplification With The Receiver - HumanTechnik Earis Mode D'emploi

1. Press the tone control button on the top of the transmitter to select the
desired profile. You can identify the set profile on the transmitter by the 5
sound profile indicator LEDs.
You can connect a maximum of two receivers to one "earis" transmitter.
The transmitter calculates the sound profile, while the adjusted sound pro-
files are stored in the receiver.
The transmitter always calculates the set sound profile of the receiver that
is switched on first.

Communication amplification with the receiver

The audio stream of the transmission can be interrupted at any time, for
example if you want to talk to a person in the room. The receiver is ready to
use this function 2 seconds after switching on.
To do this, press the function button at the top of the receiver once. The
receiver's integrated microphone now picks up the sounds of the environ-
ment and amplifies these via the receiver. The volume can be adjusted as
usual. To end the function, press the function button again to resume the
previous transmission.
Please note that the volume setting of the microphone is independent of
the volume setting of the previous transmission. The volume you have set
for the microphone is saved and used the next time you activate it.
"dynamic sound HS" is not activated when the microphone is switched on.
40 English
Earis_BA_DE_EN_F_NL_E_I_underchin180920.indd 40 20.09.2018 14:27:13