Earbuds - HumanTechnik Earis Mode D'emploi

We recommend that you always place the receiver in the charging dock of
the transmitter if the device is not used. This keeps the battery in optimum
operating condition at all times. The intelligent charging circuit in the receiv-
er prevents overcharging of the battery.
A further battery can be charged in the transmitter. Additional batteries are
available from your dealer.
The replacement battery can be inserted into the charging slot on the right
side - please remove the cover above the charging slot first. Make sure that
the slanted front edge points upwards and insert the battery without using
force. During charging, the charging status LED for the spare battery lights
red and switches to green when fully charged. The battery is thus ready
for use.
If you have a second battery, we recommend that you swap the batteries
once a week. These are then both used regularly and reach their maximum
lifetime.

Earbuds

As supplied, the larger silicone earbuds are fitted to the receiver's speaker
arms. If these buds are not comfortable for you, you will find a pair of small-
er earbuds in the delivery.
To change the earbuds, gently pull them off the speaker arms.
Then carefully insert the other two earbuds. Make sure that the earbuds fit
well and firmly.
From time to time, remove the earbuds from the receiver and clean them
with mild soapy water. Dry the earbuds thoroughly before replacing them.
In case of heavy soiling or damage, you should replace the earbuds. Re-
placements are available from your specialist dealer.
36 English
Earis_BA_DE_EN_F_NL_E_I_underchin180920.indd 36 20.09.2018 14:27:12