Choice And Installation Of Sanding Pads - Festool RO 125 FEQ Guide D'utilisation

7.1
7.2
removal (coarse sanding) and polish-
ing.
Slide the switch (6.1) into the right posi-
tion.
Eccentric motion (fi ne sanding)
This motion is recommended for
sanding with low material removal for
a scratch-free fi nish (fi ne sanding).
Press the switch (6.1) down and push it into
the left-hand position.
Choice and installation of sand-
Choice of sanding pad
The tool can be fi tted with three sanding
pads of different hardnesses depending on
the surface to be sanded.
Hard: Coarse sanding on surfaces, sanding
at edges.
Soft: Universal use for coarse and fi ne
sanding for fl at and curved surfaces.
Super-soft: Fine sanding on formed parts,
curves, radii. Do not use on edges!
Installation
The FastFix system enables tool-free re-
placement of the sanding pad:
- Set the switch (7.1) to the right for the
Rotex rotary motion,
- Press spindle stop (7.3), direction of move-
ment fi rst to the side, then forwards,
- Turn the fi tted sanding disk (7.2) from the
spindle (right-handed thread),
- Keep the spindle stop pressed and screw
7.3
on the new sanding pad (in doing so, make
sure that the rubber collar (10.1) is cor-
rectly fi tted!),
- Let go of the spindle stop.
when the drive spindle is stationary. Do not
switch on the motor when the spindle stop
is pressed in.
8
ing pads
Actuate the spindle stop only